] Mount the SENSOR with 2 cable ties on the front fork with the RUBBER PAD, and let the sensor face the spoke, do not tighten the cable ties before the sensor is placed in the right position. B0) on one spoke of the front wheel and let the magnet face the sensing zones. ] Attach the BRACKET to the handlebar and fit the RUBBER PAD between the handlebar and the band of the bracket. It can lock up the main unit, ensuring that the main unit will not drop out while riding.
Make sure the sensor cable is loose enough for the handlebar to turn freely before tightening the cable ties. Secure excess wire near the fork crown by wrapping it around the front brake cable or by bending it back and forth and securing it with cable ties. Mount the main unit onto the bracket by sliding it from front to rear till it clicks into position. To remove the main unit, press down on the lock lever of the bracket then pull the main unit forward and off. The computer can stand on the desk and act as a normal clock when you bring it indoors.
Echowell ecr2 user manual. Canada is slowing them down in the neutral zone. Options under the Tool drop down on IE. 2009-08-12 04 13. Echowell Zone 7 Bike Computer Manual Member Zone Instead of training with a handlebar computer you can connect the trainer to the Tacx Capabilities, Activities.
Replace battery with a new one within 2 weeks after the symbol was appeared, otherwise incorrect data may be display when the battery voltage is too low. Replace with a new LR44 (cross reference type A76, AG13 or V13GA) computer with the positive (+) pole toward the battery cap. This computer can be used in the rain but should not be used under water. ] 01 Km or Miles 0-99999Km or Miles 1 Km or Miles 0:00'00'- 9:59' 59' 1 Second 0:00' 12:59' 1 Minute Remark: All functions data are updated once a second.
(The original factory-attached battery may be shorter than this period due to shipping and storage time. ] DISCLAIMER TO DOWNLOAD THE USER GUIDE ECHOWELL ZONE-7 Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software: user guide, owner's manual, quick start guide, technical datasheets. In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Norton 360 5.0 60 Days. Click on 'Download the user Manual' at the end of this Contract if you accept its terms, the downloading of the manual ECHOWELL ZONE-7 will begin.
• NDEX English 1. USER MANUAL.. ECHOWELL SF-1000/SF-2000/SF-3000 PARTS. INSTALLATION..E3 How to wear the chest belt?. Buku Yuk Berhijab Pdf there. E3 4. KEY OPERATIONS..E4 5.
MODE CIRCULATION.. SETTING CIRCULATION..E5 7.
WATCH FUNCTION DESCRIPTIONS.E6 Clock Mode.. • USER MANUAL -E1. • ECHOWELL SF-1000/SF-2000/SF-3000 Echowell Heart Rate Monitor SF-1000/SF-2000/SF-3000 Your Special Force consists of 5 parts: 1.
SF-1000/SF-2000/SF-3000 MAIN UNIT 2. CHEST BELT 3.
ELASTIC STRAP 4. Spring Awakening Musical Pdf Vocal Score. BRACKET FOR BICYCLE 5. CABLE TIE X 3 -E 2. • ECHOWELL SF-1000/SF-2000/SF-3000 INSTALLATION How to wear the chest belt?
• ECHOWELL SF-1000/SF-2000/SF-3000 1. Fasten the fastener at one end, put the chest belt on your chest and loosen the stretch band.
1, 2, and 3) 2. Adjust the length of the stretch band until you feel conformable, but the stretch band must cling to the chest; then fasten the fastener at the other end. • ECHOWELL SF-1000/SF-2000/SF-3000 MODE CIRCULATION * Press MODE to change to next function. * Hold MODE 2‘s to start heart rate measure function. MODE ST/SP Hold MODE 2 seconds to start heart rate measure function. SETTING CIRCULATION Hold ST/SP 4 ‘s to enter/quit setting mode.
• ECHOWELL SF-1000/SF-2000/SF-3000 WATCH FUNCTION DESCRIPTIONS CLOCK MODE 1. 12H or 24H switchable.
Clock setting: a). Press MODE to change to “ CLOCK ” mode. Hold ST/SP 4 seconds to enter clock setting mode. Press ST/SP to change to next setting digit.
• ECHOWELL SF-1000/SF-2000/SF-3000 Countdown timer mode 1. Press ST/SP to start/stop countdown timer. There will be a 10 seconds beep when count down to zero, and OVEr will display on the LCD. Stop beep and reload pre-set data by pressing any key. • ECHOWELL SF-1000/SF-2000/SF-3000 b).
Press MODE to select setting alarm. Refer the Data Setting key operations to adjust the Alarm data. Press MODE to set Alarm ON/OFF.
Repeat steps b). To set the other alarm data. • ECHOWELL SF-1000/SF-2000/SF-3000 HEART RATE FUNCTION DESCRIPTIONS 1.Start /Stop heart rate measure function 1. Hold MODE 2 seconds to start Any tim e hold MODE 2 seconds heart rate measurement function. When the function is operating, the LCD will display the signal as follow: 3.